The daily maintenance and equipment inspection of the star unloader are particularly important. The unloader is the main accessory of the dust collector dust removal device. It consists of a reducer, an electric motor, an impeller, a shell and a seal. Any quality problems with small parts will affect the normal operation of the ash removal valve. Matters needing attention when using the star-shaped unloader: During the operation of the star-shaped unloader, avoid equipment overload caused by large material particles and firm adhesion, or due to the dust in the dust collector. Equipment blockage or motor overload caused by foreign objects. A short circuit will cause damage or damage to the equipment. It is recommended that the user check and install an overload protection device in time. During use, if the equipment leaks air or dust along the axial direction, the press cover can be fixed.

Golden Sunflower recommends the daily maintenance method of the star unloader

During transportation, the unloader should remain stable to avoid collisions and even cause the shell to rupture and deform. When the output shaft and input shaft of the star unloader and other parts are not allowed to be directly or hammered to prevent damage. The factory-produced star unloader has high machining accuracy. It can be used as a powder dosing machine for crushing and grading systems. It can also be used as an unloader for separators and dust collection systems, or as an unloader for pressure feeding and suction feeding systems. Pneumatic conveying system. The principle is that when the material in the upper silo falls due to its own weight and fills the gap between the blades, as the blades rotate, the material is discharged at the lower part. Therefore, the star-shaped slag discharge valve can discharge quantitatively Materials, and continuously. The reason why the motor is easily burned out is that the choice of the star unloader is inappropriate, and the discharge capacity is greater than that of the star unloader. The star unloader motor burned out in a short time.

The unloader manufacturer is used for the maintenance work of the motor reducer of the star unloader. The reducer has been filled with 00 lubricating oil, and the unloader (dust removal valve) has been filled with lithium grease. Within 6 to 10 months after use, the transmission and bearing components should be refilled or replaced with grease. If the ambient temperature is high, humid or there is too much dust in the air, the oil change time should be shortened appropriately. According to different conditions of use.