Maintenance method for the unloader during work
The unloader is a widely used product. In the actual application process, most of the problems will occur. After several years of experience, our factory has roughly sorted out the number of unloaders that will appear in the work. A common question for everyone to learn. The unloader is used for continuous operation to promise anyway operation. If there is air leakage or ash leakage in the axial direction during operation, the screw of the material cover can be prohibited or the material cover can be pressed after the new asbestos packing is replaced. .
1. The unloader should be filled with lubricating oil and grease before leaving the factory. After 6 months of normal use, the transmission and bearing parts should be added or replaced. If the installation environment is high or the dust is too much, it should be shortened. Change oil time,
2, the unloader is used for continuous operation to promise anyway operation. If there is air leakage or ash leakage in the axial direction during operation, the screw of the material cover can be prohibited or the asbestos packing should be replaced after the new material is pressed. You can.
3. If the material conveyed by the unloader is too large, it will easily cause the overload operation of the equipment. Simple user installs the overload protection device or replaces the high-power motor.
4, the internal structure of the various types of unloaders are the same, the disassembly sequence and the assembly process are also basically the same, in the process of transporting the unloader should be kept stable to avoid collision, resulting in damage to the casing and the motor.
This article is issued by Changzhou Golden Sunflower. If you need to reprint, please indicate the source http://www.jinkuihua178.com/